YZ rear gaurd & UFO LED light fittment.

[jakestein]

http://vsmr.net/albums/jakestein/DSC01188.jpg
http://vsmr.net/albums/jakestein/DSC01189.jpg
http://vsmr.net/albums/jakestein/DSC01190.jpg

Might fit the light then cut the edges down flush with the gaurd( it is about an inch foward in the last pic )

Would the two top bolts be enough to hold it tight? Or will it need the side bolts aswell. Maybe just one on the side will do I like the look of a blank gaurd :roll:

Going to bolt it up Monday. :)

[Wobbly]

The upper bolts would hold it, but you might find it pivots around a bit. Just drill another hole back near the end of the guard or somewhere else with a lateral distance from the other 2 that are side by side and run a screw/bolt through there. Just to stop it trying to pivot backwards and forwards, same as the acerbis led thingy :up:

[Flash]

I'm going to be doing the same thing in the next week!

[jakestein]

Final result looks cool 8)
http://vsmr.net/albums/jakestein/DSC01197.jpg

Had to cut a couple of holes underneath for the coolant bottle bracket to mount up, other then that all good. Ohh I stayed up all night to watch the GP so any slight angle problems thats my exscuse :P

[Wobbly]

Looking good :up:

I reckon that number plate could bend a bit more though ;)